Matters Needing Attention in Voice And Data Exchange in Structured Wiring

Structured

Structured wiring is a integrated wiring system composed of transmission media and related connecting hardware. Therefore, the horizontal wiring subsystem requires the use of four pairs of twisted pairs, so as to be universal.

Regardless of voice or data, they are all laid out with 4 pairs of super five twisted pairs. At the cabinet end, the data end is connected to the RJ45 patch panel, and the voice end is connected to the 110 patch panel. Whether it is a data line or a voice line, 4 pairs of lines are used. All cables should be terminated, the other end should use Cat5e 8-bit modules, and the data should be jumped to the switch and the computer at both ends using RJ45 patch cables. Use RJ11 patch cable to connect the module and phone for voice, and use red and white jumper at the 110 patch frame to jumper with the jumper frame of the outside line. Remember that the 110 patch frame should use blue and blue and white pairs of wires.

When data and voice are exchanged, there are two situations. One is to change the voice to data line. Just find an RJ45 patch cable, remove the RJ45 modular plug on one end, and connect the 8 lines to the 110 patch cable. Just put it on the rack, and plug the other end into the switch. There are also ready-made patch cables, one end is an RJ45 end and the other end is a flat mouth. If the data is changed to voice, just find and make a RJ11 patch cable, the RJ11 modular plug is plugged into the RJ45 patch panel, and the other end is connected to the telephone patch cable frame of the outside line. Similarly, to realize the exchange of voice and data, you only need to adjust the corresponding jumper in the computer room.